What settings should I put my amp on?

Getting a Good Clean Tone

  1. Select your clean channel or turn the gain down if you don’t have multiple channels.
  2. Turn off all amp effects and effect pedals.
  3. Bring the bass, mid & treble knobs all to 12 o’clock.
  4. Keep the gain fairly low and adjust the volume to a suitable level.
  5. Jam for a while to get a feel for the tone.

What are the best settings for a guitar amp?

Dialing in the perfect tone to go with high-saturation gain levels and metal riffs.

  • GUITAR: VOLUME: MAX / TONE: MAX / SELECTOR: MIDDLE OR BRIDGE.
  • AMP: BASS: 8 / MIDS: 4 / TREBLE: 4 / GAIN: 10 (or pedal) / REVERB: OFF.
  • DISTORTION PEDAL: LEVEL: AMP VOLUME / DRIVE: 75% / BASS: 6-8 / TREBLE: 3-5.

What amps did zeppelin use?

Whilst it is true that he used a Marshall 1959 Super lead during many of Led Zeppelin’s live shows, he actually played a range of different amps over the course of his career. These included amps from brands like Fender, Orange, Vox, Hiwatt and Supro.

What amp settings did Jimmy Page use?

To sound like Led Zeppelin’s Jimmy Page, start with the following amp settings: Gain: 5-6. Bass: 7-8. Mids: 6-7.

What amps did Beatles use?

Amplifiers

  • Three 1964 Vox AC-100 amplifiers (prototypes given to The Beatles by Vox at The Futurist Theatre, Scarborough on 9 August 1964)
  • 1962 Vox AC-15 Twin amplifier.
  • Two 1963 Vox AC-30 amplifiers.
  • Two 1965 Vox AC-100 guitar amplifiers.
  • 1965 Vox AC-100 bass amplifier.
  • 1963–4 Fender Bassman amplifier.

What should my LPF be set at?

As a general rule, the Low-Pass Filter should be set at a value approximately equal to (or below) 70% of your main speaker’s lowest frequency response. For example, your speaker’s frequency response goes down to 43Hz. 70% of 43Hz equals 30.1, so you should set the subwoofer’s low pass filter to 30Hz.